top of page
The Knights of Ni Present: Fusion 360 Tutorials
Motor from a Schematic: Extrusion Edition
Tools to Use: Sketch, Extrude
Do not use the revolve tool yet, this will come later.
Your task is simple. Using the tools listed above, create a 3D model of the motor in Fusion360. Make sure the screw holes on the top of the motor are 10 mm deep. You may safely ignore the vent holes and the terminals. (Hint: M3 holes are 3mm in diameter. You may also disregard the error bounds in some of the measurements.)
bottom of page